Austarion

Can someone please tell me what size the threads are for the bellhousing bolts and how far the threads go into the block? I need to get some bolts to mount my VR4 motor on the engine stand but don't have easy access to the motor to check.

thanks
martin

There m10 x 1.25 pitch. the bolts that come out of the bellhousing are to short to fit most engine stand mounting points. the thread goes into the back of the block about 15mm. Probably go and get some m10 x 85mm bolts with 1.25mm pitch. get some m10 washers aswell.

Awesome, thanks heaps for that.