Austarion

Where in NZ would I get one of these?

Repco, I'm pretty sure we still do them.

Or any bearing shop with the samples.

I have just been chasing some Wheel bearings up myself and managed to get front and rears, you will need to get them in a kit though so you get new seals as well.

I tried repco first for this and they had the part numbers but manufacture for the parts themselves. i ended up going to a bearing shop and got a kit for each Conner.
if you have had no luck let me know and ill source you the part numbers for the front and rear.

while I'm high jacking this post, has anyone got any tips for doing wheel bearings this will be my first attempt. is there anything i should know about the front Starion the bearings looked like just knock out and "press in with care" types when i was looking at them. the rears look a little different though

Got mine from Saeco Bearings, they had the correct kit for them.