Austarion

Probably a real stupid question... but is it possible to buy a gasket set for the type 2 manifold (for a JD)?

http://cgi.ebay.com/ebaymotors/ws/eBayI ... &viewitem=



:)

Thanks for the quick reply; I should buy that kit, much appreciated. I was mainly after the gasket between the engine and the manifold and after following the thread you supplied found other kits there. Is there a difference between the different manifolds or are they pretty well standard across the different models of Starion?

I just did my wifes car injection set...... withthe help of JPC and Nachoman... thanks guys.

I bought the genuine set from Mitsubishi -

Part # MD608932 and it cost $85 !!!!

it also did not include the gasket which was the critical component.
I bought some gasket paper from an auto store and cut some out....... I now have a couple of spares and still some gasket paper left.

I need to run this set through the JD next....... Redzone - how much are the US sets landed?? I assume only $5 or so postage?? and the exchange rate is OK at the moment.....

op - u need the intake manifold gasket? the one between the intake manifold and the head? why dont you go to your local car parts store and get one? no need for a throttle body kit.


and if u just want the one between the throttle body and intake manifold, then just buy some loctite 515 in a small tube, it is an anaerobic sealant that is resistant to petrol and coolant etc. just scrape the original off and use that instead of a gasket.

noddy the set is about $50au landed at the moment. getting one soon for mine probably, my widey's got a few stains around that area..

Hi Redzone

Do you normally order a few of these to cut US postage? or do we have to do it one at a time....... surell the supplier would be happy to send a few?? :)

Have you got the guys details?
I am in the US in a few weeks, maybe he could mail it to my hotel??

havnt ordered one before, but this is the set that the US guys recommend, i'll chat to you about it on friday maybe?