O2 sensor and Air temp sensor
O2 sensor and Air temp sensor
Hey guys, ive got a JA staz with an LT8 Microtech computer hooked up except for the oxygen sensor and the air temp sensor.
With the oxygen sensor there is only one wire going into the computer but four wires comming out of the oxygen sensor (2x black, white, blue), does anyone know if there is a way to hook this up?
With the air temp sensor, i dont know where it is on the engine... is there one on the standard 4G63? Again, the air temp sensor is a one wire connection...
Any help appreciated
Thanks guys.
With the oxygen sensor there is only one wire going into the computer but four wires comming out of the oxygen sensor (2x black, white, blue), does anyone know if there is a way to hook this up?
With the air temp sensor, i dont know where it is on the engine... is there one on the standard 4G63? Again, the air temp sensor is a one wire connection...
Any help appreciated
Thanks guys.
- Cookiemonster
- Mother Goose
- Posts: 3177
- Joined: Thu Jan 08, 2004 4:33 pm
- Location: Sydney
Cool so i can hook it up to my computer, do u rekon it will make much difference?Cookiemonster wrote:O2 sensor:
The two black wires are for positive and negative battery connections for the heater in the O2 sensor. (doesn't matter positive or negative for a heater element).
The Blue wire is for the O2 reading to the computer.
The white wire is the O2 reading negative - connect it to ground.
Are there any accesory 12V wires close to where the O2 sensor is located on a JA starion?
Also any thoughts on the air temp sensor?
- AB
- Mine is bigger than yours
- Posts: 281
- Joined: Wed May 25, 2005 12:27 am
- Location: Wellington, New Zealand
The factory air temp sensor is mounted inside the AFM housing which you'd normally get rid of when installing an aftermarket computer in order to run a pod air filter. It isn't much help anyway because it's before the turbo which is fine for an AFM metered system but no use in a MAP metered system. Installing a new one should be easy enough, any factory air temp sensor should work, you could get one from a junkyard for next to nothing.
Hmm, all the AFM stuff is long gone, so i dont think ill be able to find that sensor. If i did get an air sensor where abouts should i install it?AB wrote:The factory air temp sensor is mounted inside the AFM housing which you'd normally get rid of when installing an aftermarket computer in order to run a pod air filter. It isn't much help anyway because it's before the turbo which is fine for an AFM metered system but no use in a MAP metered system. Installing a new one should be easy enough, any factory air temp sensor should work, you could get one from a junkyard for next to nothing.
Thanks for your help so far guys.
- fr335tyl3r
- I'm Sorta Reformed!
- Posts: 2073
- Joined: Tue Apr 13, 2004 3:07 am
- Location: Baulkham Hills, NSW
Not sure on your specific setup - but on my car (L300 MPI Manifold) there is a threaded hole at the back of the intake manifold pretty much pointing straight to the throttle body flapper.
That's where mine is.
That's where mine is.
Multipoint Conversion Underway
http://starions.fr33z3.net/mpi/
http://starions.fr33z3.net/mpi/
fr335tyl3r wrote:Not sure on your specific setup - but on my car (L300 MPI Manifold) there is a threaded hole at the back of the intake manifold pretty much pointing straight to the throttle body flapper.
That's where mine is.
Cool ive got L300 multi-point on my car too... ill have a look for air temp sensors some time tommorow.
One last question:
Do you guys think that installing the O2 sensor and the air temp sensor will make any difference to my car?
- AB
- Mine is bigger than yours
- Posts: 281
- Joined: Wed May 25, 2005 12:27 am
- Location: Wellington, New Zealand
A narrow band oxygen sensor would only help with fuel economy at idle and cruise, assuming the LT8 can function in closed loop mode under those conditions, otherwise it wouldn't do anything.
The density of air changes with its temperature so the amount of fuel required is directly proportional to the air temperature. It probably only affects fuel economy again unless your running without an intercooler which in unlikely.
The density of air changes with its temperature so the amount of fuel required is directly proportional to the air temperature. It probably only affects fuel economy again unless your running without an intercooler which in unlikely.
-
- Enthusiast
- Posts: 605
- Joined: Thu Apr 06, 2006 2:21 pm
- Location: Christchurch,New Zealand
Who is online
Users browsing this forum: No registered users and 28 guests