Hi
See earlier subject.
After disconnecting the MAP sensor, it seemed to stop the problem. Now it has changed to when you try to accelerate hard, especially if you are in too higher a gear, the engine bogs down compleyely.
Is this because the MAP sensor is not compensating or is it indicative of the AFS being the main culprit or maybe even the ECU??? :?
As previously mentioned I am getting no output (zero volts) on the diagnostic pin 16 of the ECU.
Any ideas on how to isolate the problem?
Any suggestions would be welcome.
Regards
Steve Irwin
Cape Town calling again- nature of problem changed
-
- Newcomer
- Posts: 9
- Joined: Thu Sep 15, 2005 8:14 am
- Location: South Africa
Cape Town calling again- nature of problem changed
Steve Irwin
South Africa
South Africa
- SpidersWeb
- postwhore!
- Posts: 1984
- Joined: Wed Jan 28, 2004 2:29 am
- Location: Wellington, NZ
Dont think has car actually has a turbo. Its temporarily NA.Boris wrote:When you disconnected the MAP sensor did you plug the vacuum/ pressure tube? Iff not it will be bleeding boost.
1997 Mitsubishi Lancer Evolution IV 4G63BT
1996 Nissan Maxima VQ30DE (for sale, suit someone who likes the feel of boats when driving)
1996 Nissan Maxima VQ30DE (for sale, suit someone who likes the feel of boats when driving)
-
- Newcomer
- Posts: 9
- Joined: Thu Sep 15, 2005 8:14 am
- Location: South Africa
- logik
- I love starions
- Posts: 397
- Joined: Tue Jan 13, 2004 1:47 pm
- Location: bunbury, western australia
- Contact:
Running rich down low (computer isnt thinking the car is on boost) wouldnt be so much a problem - you might have a shitty idle (but what starion does idle well), but up high when the computer says ok he is flogging it - lets leave the injectors WIIDDEEE open
Just a thought
I havent read your other post but personally i'd just go buy a turbo!
Just a thought
I havent read your other post but personally i'd just go buy a turbo!
gordonspec® racing
Who is online
Users browsing this forum: No registered users and 13 guests