redzone wrote:3" dump pipe makes them spool quicker, the stock dump is uber restrictive..
TC05's can be ok if u wind the boost up.
Funny, I was actually just about to post some questions about the boost!
I plan to use a manual boost controller to raise my boost but I wanted afew things and I felt it was better to ask here in this thread then a new one.
like this boost controller: http://www.carmodsaustralia.com.au/gfb- ... oller-3001
Whats the stock boost?
What is a safe boost the 1983 4g63t JA can handle? 14psi to much?
Also, I remember reading something about a boost cut or fuel cut or something with the ECU and boosting it... I cannot remember what I read.. Is that a concern or will a GFB Atomic Boost Controller work?
As I've changed over my TC05 (JD type) to a TC06 (JA type but water-cooled) I suppose I should comment...
With the TC06, I added a bigger compressor wheel (17C) and a 3 inch dump, BUT the thing has too much lag before it gets going and when it does,
you're 4000rpm + and then the rush hits in. Great for the race track I suppose.
I think for the street, the TC05 is better and response down low will be more noticeable. As previously mentioned, increase boost to just under 1 bar(~12lbs)
and install hi-flo dump with a decent exhaust. With the intercooler installed it should allow enough condensed air/fuel to keep up with turbo...
I'd go for the JD turbo and enjoy the low down response! Just don't expect too much of a rush after 5000rpm!
Hi BRUZMAN ,
oh and Mal -JDSTAZ45! try a JD turbo with a HKS rally cam
Ooowesome :D :D :D :beer thats what i have in mine !!
STARSPEED
86 COLTSPEED JD STARION ( my baby )
2000 MITSUBISHI CHALLENGER LS 4X4 ( daily driver )
2010 KIA SORRENTO R ( family car )
83 stebercraft 475 DF - 70hp johnson ( my toy )