Air Filter

All technical questions and answers regarding starions, being modifications to maintenance.
GaryLingham
[L] Plates
Posts: 12
Joined: Thu Aug 04, 2011 9:27 pm
Location: Wangaratta, Victoria

Air Filter

Post by GaryLingham »

How do you go about hooking up a aftermarket pod filter instead of having the air box with the sensor??
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

Difficult to achieve & gives you no extra performance..
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
User avatar
Sargeant_Khan
Enthusiast
Posts: 673
Joined: Thu Dec 16, 2004 9:31 pm
Location: Ipswich

Post by Sargeant_Khan »

probably easier to obtain/replace than the stock one though dave?
Image
PIZZA DELIVERY GUY....No more
FST4RD
almost postwhore
Posts: 1223
Joined: Sat Dec 09, 2006 10:22 am
Location: Christchurch

Post by FST4RD »

Cut most of the airbox out and wire it up. I bought my starion with this done and it works fine. Here's a pic:

Image
Sold - 1987 Mitsubishi Starion GSR V DASH
Current - 1995 Subaru Legacy TT SW
- 1983 Mitsubishi Starion
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

Sargeant_Khan wrote:probably easier to obtain/replace than the stock one though dave?
nah any parts shop should supply easy, as long as u dont go to supercheap or autobarn which are staffed by people resembling the spotty voice breaking teen from the simpsons!

i ran 13.8 with a stock uncut airbox on my first JA, just disconnected the air feed from the guard and ran a cold air pipe to it..
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

Make your own.

Image

Image

Image

Image

Image
GaryLingham
[L] Plates
Posts: 12
Joined: Thu Aug 04, 2011 9:27 pm
Location: Wangaratta, Victoria

Post by GaryLingham »

Are you still running the sensor or have you bypassed it?
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

I'm running one of these MAF translators

Image
Image

with a GM LS2 sensor

Image
The beauty of this set up is you can run the MAF post intercooler and
atmospherically vent a CBV,if you run one, without effecting your emissions... mmmm upstairs for thinkin', I say :)
GaryLingham
[L] Plates
Posts: 12
Joined: Thu Aug 04, 2011 9:27 pm
Location: Wangaratta, Victoria

Post by GaryLingham »

So this will bypass the other sensor completely? will you have to re map for this?
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

You don't have to re-map your ECU and yes you get rid of the kharman vortex AFM. I also run a jaycar FCD to combat the boost limit. I strongly suggest using an A/F ratio gauge (wide band) to tune it in.

http://forums.austarion.com/viewtopic.p ... highlight=
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

running a vent to atmo bov will still affect emissions, namely crankcase ventilation, and also turbo's always emit SOME oil into the air coming out of them, so it'll fail on that count too..
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

redzone wrote:running a vent to atmo bov will still affect emissions, namely crankcase ventilation, and also turbo's always emit SOME oil into the air coming out of them, so it'll fail on that count too..


Perhaps under emissions laws in QLD. So you're telling
me you can't tune a starion using a post turbo AFM
arrangement & still running the factory PVC system to comply
with emission laws pre 1986 which is all you're legally bound
to abide by? Honestly? Now...., hands up who owns a starion
that would pass an emissions test in their state tomorrow?

Technically if you had to put it over the pits, the engineers would
fail you on either noise or the standard (For off road use only)
My vr4 is registered and engineered in N.S.W with the identical
set up. My Hybrid GT spec IC and aftermarket IC piping is also
on the same engineers report. 14 pages last time I checked.

Have I poked the hornets nest yet :twisted:
redzone
racking my brains
Posts: 5900
Joined: Thu Oct 06, 2005 10:46 pm
Location: sunshine coast qld
Contact:

Post by redzone »

vr4gone wrote:
redzone wrote:running a vent to atmo bov will still affect emissions, namely crankcase ventilation, and also turbo's always emit SOME oil into the air coming out of them, so it'll fail on that count too..


Perhaps under emissions laws in QLD. So you're telling
me you can't tune a starion using a post turbo AFM
arrangement & still running the factory PVC system to comply
with emission laws pre 1986 which is all you're legally bound
to abide by? Honestly? Now...., hands up who owns a starion
that would pass an emissions test in their state tomorrow?

Technically if you had to put it over the pits, the engineers would
fail you on either noise or the standard (For off road use only)
My vr4 is registered and engineered in N.S.W with the identical
set up. My Hybrid GT spec IC and aftermarket IC piping is also
on the same engineers report. 14 pages last time I checked.

Have I poked the hornets nest yet :twisted:
No, you've just shown how little you know..

In qld, they dont test for exhaust emissions. a simple check under the bonnet will show if a car has all it's pollution gear hooked up though.

Positive crankcase ventilation is an ADR, THAT is the reason vent to atmosphere BOV's are illegal on cars/engine's made after 1974..
Fibreglass airdams $370, fibreglass front bumpers $260, reco drag links $165, alloy radiators $925 (unpolished), h/l switch rebuilds $125, all plus freight.
Coxs Automotive (07)54433507 3/5 Service st Maroochydore Q

www.facebook.com/coxsautomotive
www.coxsautomotive.com.au
vr4gone
I like starions more
Posts: 187
Joined: Wed May 13, 2009 1:23 pm
Location: Western Australia

Post by vr4gone »

redzone wrote:
vr4gone wrote:
redzone wrote:running a vent to atmo bov will still affect emissions, namely crankcase ventilation, and also turbo's always emit SOME oil into the air coming out of them, so it'll fail on that count too..



No, you've just shown how little you know..

In qld, they dont test for exhaust emissions. a simple check under the bonnet will show if a car has all it's pollution gear hooked up though.

Positive crankcase ventilation is an ADR, THAT is the reason vent to atmosphere BOV's are illegal on cars/engine's made after 1974..
So the Hornets are out.. nice. Doesn't the PVC valve route straight into the inlet manifold on a starion? Anyway this is how little I know. Currently ADR79/02 covers cars from 1972, not 1974 and
ADR27B, ADR27C+ and ADR37/00 are the emission rules that cover from 1/1/1982 - 1/2/1986. These are the federal rules that engineers will reference against any state rules to determine the if a light vehicle built before 1989 is legal. I suggest you check the reference in regards to vehicles built pre 1989. Now run along and "Tony Abbott" some other topic.
NachoMan
nearly postwhore
Posts: 1589
Joined: Sat Jan 10, 2004 12:28 pm
Location: Perth (Morley), WA
Contact:

...

Post by NachoMan »

Image
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests