Idle drops low when the clutch goes down

All technical questions and answers regarding starions, being modifications to maintenance.
Post Reply
traser
Lil' Dorifto
Posts: 44
Joined: Thu May 28, 2009 9:19 am
Location: England

Idle drops low when the clutch goes down

Post by traser »

any ideas? car idles high when started (1100-1150rpm) yet when I drive it and drop the clutch to change gear/stop the revs drop to under 350rpm, nearly stalls.

Any input appreciated, Steve
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

used to happen in my old car.. could have been one of three problems for me..

1. my idle control motor was missing LOL
2. my old car had a horrible case of leaky injectors
3. the timing goes out because of movement in the timing gear.

Not sure if this helps you, but this is what I've come accorss.
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
traser
Lil' Dorifto
Posts: 44
Joined: Thu May 28, 2009 9:19 am
Location: England

Post by traser »

thanks for the reply, played around today.


first start the car, low idle (400), quick rev and idle settles at 800.

then everytime you rev the engine the idle will drop to 300 and slowly pic back up to 800.

also slow at dropping revs. any ideas guys? loosing the will with the car now!!
fugazi
Enthusiast
Posts: 716
Joined: Thu Oct 02, 2008 10:30 pm
Location: Stockholm, Sweden
Contact:

Post by fugazi »

Stuffed idle control...
Image
traser
Lil' Dorifto
Posts: 44
Joined: Thu May 28, 2009 9:19 am
Location: England

Post by traser »

Fugazi, I think idle control could well be the culprit, although prior to the rebuild I dont remember it having this problem?

Is the idle control the black rubber sheathed piston that pushes on the tab of the throttle pulley?

If so anywhere this can be tested/ should it be visibly moving etc?
My manual only shows the 2.6 TB :(

Thanks guys

Steve
Post Reply

Who is online

Users browsing this forum: No registered users and 21 guests