L200 boxes
L200 boxes
Is it possible for the box from a 4g63 l200 to bolt up to a 4g54 motor?
87 GSR-V, Factory DASH, Rebuilt bottom end with arp rod bolts and balance shafts removed, head reconed with 3 angle valve grind, TD05 housing machined out to take Garrett T4 internals, rebuilt and cryoed gearbox
-
sigmaproject
- Big Dorifto
- Posts: 91
- Joined: Fri Jan 16, 2004 10:34 am
- Location: Maitland
As long as the 4G54 block was a factory RWD manual it will fit.
No good for an RWD auto block and no good with any FWD Magna blocks.
Must be 330mm between the dowls for a 4G63
( Ignore the 310mm spacing in the pic. That is for RWD 4G54 auto blocks and all 4G52 blocks, as well as FWD Magna blocks used in RWD vehicles)
No good for an RWD auto block and no good with any FWD Magna blocks.
Must be 330mm between the dowls for a 4G63
( Ignore the 310mm spacing in the pic. That is for RWD 4G54 auto blocks and all 4G52 blocks, as well as FWD Magna blocks used in RWD vehicles)
You'll definately need to measure, everything I have read about the L200 has the 4g63 version running a Narrow Block (like sigma's) and the 4G54 version (like mine) running the Wide Block.
1988 Mitsubishi Starion EX Widebody
1987 Mitsubishi Starion EX
1991 Mitsubishi L200 Double Cab Sport
2010 Holden Colorado Ute
1987 Mitsubishi Starion EX
1991 Mitsubishi L200 Double Cab Sport
2010 Holden Colorado Ute
Who is online
Users browsing this forum: No registered users and 8 guests