Austarion

Hi Everyone, Does anyone know what the cam angle sensor o-ring size is?

Part number is either MD611831 or MD619648 (superseded part number)

On a separate note, have people just used RTV for the water pipe at the back of the head? There seems to be a gasket part number MD145038, but I'm wondering if most people just use RTV instead of these ultra hard to find parts

Cut mine out of gasket paper

thanks for being the only one to respond lol :beer

mizuno man wrote:Cut mine out of gasket paper

how do you cut an o-ring out of gasket paper?

and also that didnt answer the question of what size the o-ring was either...?

Re the o-ring, measure the diameter of the groove, the width and the outside diameter of the shaft. Go to a bearing place or industrial supply place and get the size required. May even cost a dollar to buy a couple of them.

thanks guys, www.18u sorted me out :beer