Page 1 of 1
Identifying factory camshafts
Posted: Tue Sep 18, 2012 12:10 am
by enthuzed
Okay, I've got a bunch of sets of camshafts and cam pulleys lying around and I want to be able to identify what they came out of and therefore the specifications.
I have e39a Galant, apparently VR4 ones and who knows what the others are from.
Are there codes or marks to identify what they are?
None have the CAS trigger on the cam pulley so that rules out RVRs and the like...
Posted: Tue Sep 18, 2012 3:47 pm
by fugazi
I've made an .xls-file with some cam-data stored on the MCS-forum, if it's of any help?
Partley in Swedish, byt I think you'll get it anyway...
(I DON'T guarantie any of it is correct though!!! Have't measured any cams, just taken data of manuals and so on...)
http://mitsubishiclubsweden.se/forum/do ... hp?id=1436
Posted: Tue Sep 18, 2012 11:42 pm
by enthuzed
Thanks fugazi, I don't know what A through G are for.
Also, what are these words in English?
Kamhöjd:
Insug
Nock i mm.
Posted: Tue Sep 18, 2012 11:51 pm
by fugazi
Insug nock i mm=intake lobeheight (basecircle+lobe) in mm.
Avgas=exhaust
Hope you can use it!
A-G should be marked in the ends of the cams...
Didn't bother to put in what they came from/what vehicle.
Posted: Wed Sep 19, 2012 12:02 am
by enthuzed
fugazi wrote:
Didn't bother to put in what they came from/what vehicle.
Could you please, if you know...
Posted: Wed Sep 19, 2012 4:58 am
by fugazi
Does it matter?
A lot of them comes from the 2.0 galant and various countries/models... some onley from the 1.6 colt GTi...
It would probabley take me a week or 2... looking through manuals and several forums... not especialy happy about that...
