Harmonic balancer type
Posted: Sat Aug 20, 2011 11:11 am
hey guys,
discovered last night that the standard balancer had torn the inner rubber section from the outer and was wearing into the timing case, strange faint whirring like a dodgy bearing. al suggested we whip the timing case off thank god while we were at it and there it was, like a 200mm holesaw half way through the case.
good timing.
question is whats the part to get as a replacement?
hyundai one or mitsi one?
and will it need to be balance at zero or are they weighted to suit already?
cheers
mick
discovered last night that the standard balancer had torn the inner rubber section from the outer and was wearing into the timing case, strange faint whirring like a dodgy bearing. al suggested we whip the timing case off thank god while we were at it and there it was, like a 200mm holesaw half way through the case.
good timing.
question is whats the part to get as a replacement?
hyundai one or mitsi one?
and will it need to be balance at zero or are they weighted to suit already?
cheers
mick