Page 1 of 1
My Dohc conversion..
Posted: Thu Aug 13, 2009 7:07 pm
by STARZILA
Engine and box moved foward 50mm.
Vertical thermo outlet.
Starion water pump (pressed vr4 drive on and machined it down a little)
Evo 2 Head (small port) with RVR N/A Inlet,and evo ecu,turbo etc.
GTO twin turbo throttlebody.
Staz block.
N/A galant crank.
Forged pistons.
And a flux capacitor..
Show Image:
Show Image:
Show Image:
Posted: Thu Aug 13, 2009 8:46 pm
by Entaran
Can I ask how you spaced the gearbox forward? Did you have to get a custom tailshaft?
Posted: Fri Aug 14, 2009 4:28 pm
by STARZILA
Entaran wrote:Can I ask how you spaced the gearbox forward? Did you have to get a custom tailshaft?
No, the car already has holes for the crossmember 50mm forward. (for auto maybe?) :D
Yeah, re-tubed driveshaft man.
Posted: Sat Aug 15, 2009 4:38 am
by iXNAY
where is the turbo?!
its so tiny man you def need to get something a bit bigger!
Posted: Sat Aug 22, 2009 6:38 pm
by STARZILA
iXNAY wrote:where is the turbo?!
its so tiny man you def need to get something a bit bigger!
Haha. yeah i wana get it going first though. Isnt a factory evo1 180KW?
Posted: Wed Dec 02, 2009 5:52 pm
by JAS
Nice work mate.
Are you going to put some sort of bleed in your Vertical thermo outlet?
Posted: Wed Dec 02, 2009 11:31 pm
by juice_2
NOT TO PUT A FLY IN THE OINTMENT OR ANYTHING CAUSE IT LOOKS GREAT,BUT THE PIPE FROM THE THERMOSTAT IS TOO HIGH IT WILL CONTINUALLY AIR LOCK. BETTER TO RUN IT LOW.
Posted: Wed Dec 02, 2009 11:45 pm
by juice_2
pipe should not go higher than the top tank inlet, found it out after building a few hotrods
Posted: Wed Dec 02, 2009 11:46 pm
by juice_2
just out of curiosity what inlet manifold is that off of?
Posted: Thu Dec 03, 2009 12:04 am
by enthuzed
^ +1
Re: My Dohc conversion..
Posted: Thu Dec 03, 2009 7:31 am
by Alspos
STARZILA wrote:....Evo 2 Head (small port) with RVR N/A Inlet,....
Posted: Thu Dec 03, 2009 10:35 pm
by enthuzed
Yep, missed that. Thanks Al.
Posted: Tue Dec 08, 2009 5:39 pm
by STARZILA
juice_2 wrote:pipe should not go higher than the top tank inlet, found it out after building a few hotrods
Yeah I was going to put a bleed valve in there, but im going to bin that pipe now and re route it :P