CAS O-Ring Size?

For all your twin cam conversion questions and hints
Post Reply
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

CAS O-Ring Size?

Post by thrash »

Hi Everyone, Does anyone know what the cam angle sensor o-ring size is?

Part number is either MD611831 or MD619648 (superseded part number)

On a separate note, have people just used RTV for the water pipe at the back of the head? There seems to be a gasket part number MD145038, but I'm wondering if most people just use RTV instead of these ultra hard to find parts
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
Top
mizuno man
Dorifto!
Posts: 55
Joined: Mon May 03, 2010 1:49 pm
Location: Brisbane

Post by mizuno man »

Cut mine out of gasket paper
Top
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

thanks for being the only one to respond lol :beer
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
Top
User avatar
iXNAY
nearly postwhore
Posts: 1414
Joined: Sun Jan 30, 2005 2:30 pm
Location: Bathurst

Post by iXNAY »

mizuno man wrote:Cut mine out of gasket paper
how do you cut an o-ring out of gasket paper?

and also that didnt answer the question of what size the o-ring was either...?
SR20 powered starion what have I done..... :P
Top
User avatar
Alspos
Flucking kwankers
Posts: 4107
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:
Contact Alspos

Post by Alspos »

Re the o-ring, measure the diameter of the groove, the width and the outside diameter of the shaft. Go to a bearing place or industrial supply place and get the size required. May even cost a dollar to buy a couple of them.
Top
User avatar
thrash
Austarion Occupant
Posts: 3028
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Post by thrash »

thanks guys, www.18u sorted me out :beer
quest wrote:
WANTSOM wrote:Personally, I find sloppy boxes very unsatisfying. I like them tight and taught to the point that if you dont have to push to get it in then its probably too old and time to get a new one :P
don't try explaining that to her tho..... just leave. lol
Top
Post Reply

Return to “Twin Cam Land”

Who is online

Users browsing this forum: No registered users and 1 guest