Page 1 of 4
Adel Cruise - March 12
Posted: Wed Feb 07, 2007 8:43 am
by decoy
Thought i'd create a new thread for the next cruise.
the 12th is on the actual pubhol, Monday. Toys has a tight time frame to get his beast out for this date but he's not gonna fail us! hehe
Who's able to make it?
Posted: Fri Feb 09, 2007 12:30 am
by Neon_Crossing
As always buddy.......im in!
Posted: Mon Feb 12, 2007 6:17 pm
by tint
i'll be there this time!
Posted: Wed Feb 14, 2007 11:53 am
by toysrus
As you can see there is no crankshaft in the Block yet as I'm waiting on the Flywheel to come.....and when it does get sent off it'll be about 2 1/2 weeks in the Air and with Customs before I get it.......then it goes off with the Crankshaft and new Harmonic Balancer to be all balanced up
So yeah, its gonna be tight to get it ready on time
Can't say I didn't try though....
Posted: Sat Feb 17, 2007 3:21 pm
by tint
should have got deep dish could run higher boost.
Posted: Sat Feb 17, 2007 4:05 pm
by SIR GSR
You should invite Chief along....
His car would most certainly fit in, and being blue.....has gotta be the best presented :D
Posted: Sun Feb 18, 2007 6:05 pm
by toysrus
tint wrote:should have got deep dish could run higher boost.
Static CR will be 8.3:1, will have no problems running 24psi on PULP
Posted: Sun Feb 18, 2007 6:07 pm
by toysrus
Cheif is more then welcome :beer
Posted: Sun Feb 18, 2007 9:16 pm
by decoy
SIR GSR wrote:You should invite Chief along....
His car would most certainly fit in, and being blue.....has gotta be the best presented :D
haha, it'll break up the array of red and white that's for sure!
Posted: Mon Feb 19, 2007 3:19 pm
by RiceThief
toys what pistons are they, they dont look like cast pistons.
Posted: Mon Feb 19, 2007 8:49 pm
by toysrus
RiceThief wrote:toys what pistons are they, they dont look like cast pistons.
You can't buy new Forged Pistons and Rings for $350
Could have got Hypereutectics' but I'ld rather take my chances with OEM quality :)
Posted: Mon Feb 19, 2007 9:35 pm
by RiceThief
Its obvious they're not forged with the cast marks on the valve reliefs but there arent any cast marks on the dish area, is that normal for oem pistons?
Posted: Mon Feb 19, 2007 9:55 pm
by toysrus
RiceThief wrote:Its obvious they're not forged with the cast marks on the valve reliefs but there arent any cast marks on the dish area, is that normal for oem pistons?
These Pistons are available in different CRs' so I'm assuming that they are firstly cast with the Valve reliefs but no dish at all and then they have the dish machined out for different Engine specs.
Posted: Fri Feb 23, 2007 7:32 pm
by tint
toysrus you might blow head gaskits. o ring the block would have been the other option. [/quote]
Posted: Fri Feb 23, 2007 8:50 pm
by toysrus
Are you serious ? rofl
If I blow the Head gasket, I'll buy you a beer
:beer
