I liked this one

If you think it might offend someone, chuck it in here where the wusses don't look!
Post Reply
User avatar
madeofmilo
Enthusiast
Posts: 578
Joined: Fri May 21, 2004 5:53 pm
Location: Melb - East

I liked this one

Post by madeofmilo »

Poor Pirate

One day a Pirate and a bartender were talking to each other in a bar. The Bartender asked the pirate "Where did ya get that peg leg from?"

The Pirate responded "We were sailing the seas when a big ol shark came up to me while I was swimmin and bit off me leg."

Later the Bartender asked "Where did you get that hook then?"

The pirate responded "Well, me crew and I were in a battle and it got cut through the bone."

The bartender then asked "Then where did ya get the eye patch from?"

The pirate said "In a harbor I looked at a gull flying over head and it took a dump right in me eye."

The bartender was puzzled and asked the pirate, "How would that make you get an eye patch?"

The pirate responded, "First day with the hook."
My JA has perfect motor - FMIC - forgies - high flow head but...rusted front guards and keyed on every panel. Time to get serious or time to take it to the tip.
User avatar
SIR GSR
Loose Cannon
Posts: 1359
Joined: Thu Oct 06, 2005 12:00 pm
Location: On boost in Cairns

Post by SIR GSR »

LOL...It's funny coz it's true
KBS Drift Team
0409 487 321
Image
User avatar
scum
I'm Banned!
Posts: 1412
Joined: Fri Jan 09, 2004 12:49 pm
Location: Perth WA

Post by scum »

better hope ya dont get caught in the zipper. there’s a good possibility of pain there.
I figured out the meaning of life, and since then every day just gets worse.

Warranty void if stupid.
Mick
Enthusiast
Posts: 643
Joined: Sun Mar 12, 2006 1:37 pm
Location: Hobart, Tas

Post by Mick »

LOL
FS: Ford 302ci Windsor. Race prepped block, Clevite bearings, ARP fixings, Hypertectic pistons, nitrided rods, knife edged crank, Gilmer drive, chrome moly rings, Yella Terra stage 3 heads, manly valves, Comp cams 294* solid roller, YT roller rockers, Funnelweb manifold, 2 inch spacer, Proform 830cfm carb, K&N 10" stack, ICE ignition. - 0437900210
Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests