Austarion

How about the RVR HyperGear? Isnt it meant to have (basically) an EVO 3 donk? Could this engine be used as a head and accessories donor as well? I have read it may use a crank & cam angle sensor as well - but would this even matter in our situation? As I would be converting to rwd and using an ...

Get the N/A... cheaper & you can't use the VR4 manifold anyway. :beer I trust you can use a VR4 cyclone inlet manifold on a N/A Gallant head with large ports? Or is it a no-go?? What's all this tricky air flow? Will a tuner be able to dial/tune this low rev stuff out? Yep for sure... as for tun...

Get the N/A... cheaper & you can't use the VR4 manifold anyway. :beer

Thats just casting flash... Don't worry about it. As for the Front bolt, use impact air gun! Remember to tension it back up when you put it back on!!!! This is most important. :beer

^^^^^ I second that! Plz get this thread updated with pics including the power steering stuff you have on offer, Dave. And a question for you Dave, if a starion motor is a already built with twin cam pistons but the bottom end is also starion... pulleys, pumps and shafts etc, would there be a lot o...

Aaron where di you get that one from.. how is it going over there?

avandull wrote:ARP head studs for Starion are 2007-4201

I just checked my stock... 207-4202 2,6L head studs. :beer

mptybox wrote:Is it enough to use washers, or maybe a nut with larger inside diameter?

No.

Good story! If only the Staz wasn't TAKEN out! ( they knew it was quick...very QUICK ) & didn't use tyres... There was discussion in the pits of WHO would take it OUT...... :glare:

Burnt or bent valve... :beer

Ok I have them







:beer

Na... looks like the spark went out... broken lead? Is is COP ignition? :beer

ARP 207-4701 are 12mm units, you will need to use a 10mm spacer as they are to long for our 4G63. :beer

Bargin!!! :beer

I C...

These too..

http://forums.austarion.com/viewtopic.p ... 9&start=15

& Here....

http://forums.austarion.com/viewtopic.p ... 0&start=15