Austarion

Nah its made of rocking horse shit :D NZ$795 works out to be AU$620, cheaper than most of the others I've seen on here: http://forums.austarion.com/viewtopic.php?t=12993&highlight=lsd http://forums.austarion.com/viewtopic.php?t=12719&highlight=lsd http://forums.austarion.com/viewtopic.php?t=...

Auction closing tomorrow. Am happy to send to Australia at buyer's expense. Best quote so far is NZ$295 door to door air freight (East Coast / Tasmania). If the diff went for NZ$795 it would work out to be AU$850ish delivered.

Mitsubishi Starion limited slip diff. 8" crownwheel, 3.909:1 ratio, 4 bolt CVs. Removed from running car in good working order. Auction includes complete diff head with LSD nugget, torque tube, CV joints and axles
http://www.trademe.co.nz/Browse/Listing ... =316422803
Start=reserve NZ$795.

1983 Mitsubishi Starion GSRIII Turbo Warranted and registered Rear wheel drive 4 wheel disc brakes Independent rear suspension Euro-spec front bumper with airdam Engine rebuilt approx 20,000kms ago Kelford cam Modified TD05-14b (VR4) Turbo 2.5" mandrel bent dump pipe 2.5" straight through ...

Did a compression test and found 2 and 3 were down. Turns out the head gasket had gone between cylinders. All sussed now =)

Had a good look for leaks but no luck. The idle is steady (ie not surging), it just misses at idle and idles quite low, then feels really sluggish until it comes on boost. Almost feels like it's running on 3 cylinders at low rpm?

Not sure? It's an '83 Jap spec, factory intercooled and has the oval shaped inlet on the intake manifold.

My Jap spec GSRIII seems to be running pretty poorly at low revs. Idle is rough and seems to miss and be down on power up to about 2500rpm. Once it comes on boost it seems to run a lot better. I've checked timing, coil, plugs, leads, replaced fuel filter etc. AFM seems to be working? Its a standard ...

PMs sent

Nah Prozac already gave him a ring, he hasn't got one

Looking for a factory air flow meter and filter housing to suit an intercooled Jap-spec starion. Let me know what you've got

It won't go at all when he's asking that price. I'd say NZ$5000 is about the going rate for a tidy NZ new Starion? "toughened bottom end and heat treated head" Righto mate :roll:

Sorry, I realise this has been covered before, but I just wanted to claify a few things about doing the twin cam conversion. Let's assume I have both a complete Starion engine and a complete VR4 engine with loom and ECU. Having searched through the old posts it seems to me that these are the main ch...

I'm after a non jet valve SOHC 8V head to suit a 4g63. Must be in good or at least servicable condition (not cracked/warped) with cam, rockers etc. Let me know what you've got. Thanks

Better not forget the 'controversial' front mounted TX5 intercooler..