Austarion

I am running a td05 16g from turbonetics onto my 2.0. This was a true direct bold on upgrade. To mine opinion it is nice for top end power. Stock 8v engine goes straight to 6500 rpm without any problem. However with the long gear sets that came stock in the starion I woud chose a smaller one now suc...

Has Anyone tried to put an E55 2.0 16 valve SOHC head onto our old 4g63t 8 valve engines? The headgasket looks the same and perhaps swapping from sohc to sohc is à lot easier then swap to DOHC.

OLD FART wrote:SOHC motors are not interferance so if you break a cam belt nothing hits and gets bent so your choice of pistons will be fine :)
If the same thing happens in a DOHC $$$$$ :(

But is it still non interferance when you use pistons with a comp ratio of 9,0:1 and a stage 2 cam?

I want to put forged pistons in my starion 4g63 SOHC. I have a RPW stage 2 cam. Does anyone knows what pistons can be used to behold the valve clearance? I was thinking about the wiseco 9.0:1

Does anyone have a ECU pin out from a JD 2.0?

I own a 1988 widebody 2.0 and can't find the pin out anywhere.

So perhaps the pin out of a JD is the same.

Thx

Johan

I have a 1988 widebody 2.0 with a six bolt rear axle. Do you guys know if I can fit the LSD from a 2.6 1988 6 bolt in it. Or will the endgear be a problem?

Hi there, I have doen the igntition module upgrade from Bosch but the car is not starting. I have measured the voltage on the negative side of the coil and I am measuring only 2,6 volt. According to the manual it says that or the dizzy is broken or the coil is broken. My question how can I test my d...

This is indeed a 4G64 manifold with the throttle body replaced. I also have a 4g64 head on it.

Here is a picture of the TD05 16g Turbonetics

Try the Turbonetics td 05 16 G stage 2 starion upgrade. This will fit directly onto your engine. The only thing different is the outlet. This turbo is meant for the intercooled engine, but if you do this upgrade a front mount intercooler is appreciated too. If you really want a bolt on try the turbo...

Can anyone tell me what happens if the knocksensor brakes down or is disconected. will the engine spark control work well or will it work on emergency mode? or can it effect the coil/negative signal?

4g63 8 valve 1983 turbo engine.

Kind regards,

johan

I have the blue tokico´s. And they are very good. Still a smooth ride but cornering is great! I also added the sway bars form suspension techniques front and rear also very good upgrade. The Tokico´s are not that expensive.

Johan

Some tuningchips comes with a fitting instruction to increase boost also and then a chip can gain that much power. For example increase your boost to 1.0 bar by using e.g. a bleedvalve and then the chip can increase the fuel cut en also increases fuelling for the higher boost, so you have to ask to ...

you can add a fuel cut defencer from HKS onto your galant if it is modelyear 1981/1984

I have fitted a new Turbonetics TD 05-16 G stage 2 onto the 4g63 8 valve. This fits very fine onto starion and no additional work required direct bolt on including exhaust system. Spools very fast!, max boost available at 2000 rpm. Can support 350 hp. More info www.turboneticsinc.com but I am not su...