Austarion

Once I have just finished my engine today I will tell you the whole story. I have a pajero 89-90 model and I am using a starion motor in it for 10 years now. The engine is stock motor with a tc-06 turbo. Before 5 years I did a full rebuild of the Motor and used the 16 valve pistons everything fits o...

now that i look at it better you are right redzone the gasket looks it is for the dohc but the seller says that it is for the starion 4g63 engine. i will ask the seller and get back tou you guys and tell you.

thanks for all your replys guys.

i can see that the turbo may not be something good im thinking of using all the rest of the things and especialy for the exaust manifold and buy a original garrett turbo to put on. over here only to fix the exaust manifold it will cost me more money than all the kit. so exept from the turbo does all...

hello there everyone can you have a look at this turbo kit and give me an advice is it ok to buy it? this is a very cheap kit for me that i live in greece. http://cgi.ebay.com/ebaymotors/82-90-Mitsubishi-Starion-4g63-T3T4-Turbo-Charger-Kit_W0QQcmdZViewItemQQhashZitem518c2d577aQQitemZ350244132730QQpt...

BOSCH Ignition Module Conversion mentioned in the Technical Section is perfect for the starion. i think it works better then the original.

all mitsubishi 2.0 8v heads will be a bolt up no modified needed.

perfect pistons for your setup. i always use those pistons no problem with your valves.

leave it like that. do not put it anywere.

Hi there I would just want to ask is the head gasket from a 2 litre starion motor the same as the 2 litre naturally aspire g63b?

Haltech E6X is a fantastic aftermarket ecu for mpi setup at a starion engine .I have been using it for almost 5 years and it woks perfect .and also it is still available.

No redzone this is not true .the air/fuel does not change over boost. This has been tested on the dyno the only problem is that at 15psi of boost the the air/fuel mixture goes from 10.5 that was stock to 13.

i have just done it at my engine every thin is working fine with 15psi and no intercooler

starions use 21 pin later model mitsubishi use 22 pin

What do you mean your own ecu? How is that so if you’re running mpi?

hall effect. trigger and home edge is rising. trigger angle will be 50 if you are using your dizzy and not waste spark. spark edge will be falling and charge time is 4.0ms.