Search found 642 matches

by Mick
Thu Aug 28, 2014 6:34 am
Forum: Buy / Sell
Topic: WTB: Gearbox linkage boot
Replies: 2
Views: 416

Thanks Dave,

Good tip!
by Mick
Sun Aug 24, 2014 7:52 pm
Forum: Buy / Sell
Topic: WTB: Gearbox linkage boot
Replies: 2
Views: 416

WTB: Gearbox linkage boot

Hi all,

As per title, anyone who has a linkage boot in good nick with no splits im very interested.
Postage to 7009 also.

Mick
by Mick
Thu Aug 21, 2014 5:21 pm
Forum: Technical
Topic: Wheel Offset Guide
Replies: 109
Views: 22343

Tomsun, To complete the 19" wheel package on the first page. Tyres are: 215/35/19 Front 245/30/19 Rear Wheels are +12 offset front and rear not +6 as listed (my fuck up). Comments: With stretched tyres and 2 inches of pumping, rolling and cutting the rear wheels just fit. Fronts need rolled gua...
by Mick
Thu Aug 21, 2014 5:13 pm
Forum: Technical
Topic: Linkage boot replacement
Replies: 0
Views: 757

Linkage boot replacement

Hi all,

Does anyone know where to grab a replacement linkage boot which sits at the base of the shifter over the linkage and bush?
Mine has split some time ago and has been spewed gear oil out into the tunnel
Appreciate any help!

Mick
by Mick
Sat May 03, 2014 5:02 pm
Forum: Buy / Sell
Topic: FS: JA steering set up, twin cam bits, wheels, JB bar
Replies: 11
Views: 540

Mteck, got a quote for the bar and lights to melb CBD for around $40, doesn't sound too bad!
by Mick
Fri May 02, 2014 7:15 am
Forum: Buy / Sell
Topic: FS: JA steering set up, twin cam bits, wheels, JB bar
Replies: 11
Views: 540

No dramas at all, will take photos as it progresses, and if there is interest will post it up.
Mteck, sms'd you back yesterday did you get it?
Prozac, its non power rack, no pump, no pulley, no lines :)
by Mick
Thu May 01, 2014 4:00 pm
Forum: Buy / Sell
Topic: FS: JA steering set up, twin cam bits, wheels, JB bar
Replies: 11
Views: 540

Its in the early stages but had a tip on a Hyundai rack from a 97 from John on this forum.
It need to be modified in width to suit the starion ends and have the same geometry as the standard steering arc.
Then needs to link up to factory column and be bolted to a fabbed up crossmember.
by Mick
Wed Apr 30, 2014 8:45 pm
Forum: Buy / Sell
Topic: FS: JA steering set up, twin cam bits, wheels, JB bar
Replies: 11
Views: 540

FS: JA steering set up, twin cam bits, wheels, JB bar

Hi all, For sale: 1. complete steering system from a JA with twin cam. - Steering box was rebuilt 200km ago by National Power Steering in Sydney for $600. - New bushes - Twin cam power steering pump and belt, has always been ok but isn't new. - Fake braided lines and polished reservoir. - All arms a...
by Mick
Fri Dec 20, 2013 6:52 am
Forum: Technical
Topic: No power after turning off engine
Replies: 12
Views: 557

In the technical section the wiring diagram probably describes what amperage the fusible link is.
As far as cable guage goes just make sure it is no smaller than what is already there.
That matched with the right fuse will have you sorted.
by Mick
Thu Dec 19, 2013 2:00 pm
Forum: Twin Cam Land
Topic: Is a Tremec T-56 strong enough?
Replies: 15
Views: 1385

Aaron,

have become a huge fan of the t-56 due to the option of ratios and also a couple of consistent flat 11 sec cars down here run them in old school all steel cars with no dramas, season after season.
by Mick
Thu Dec 19, 2013 1:52 pm
Forum: General Discussion
Topic: Happy Christmas
Replies: 14
Views: 922

Here here.
Be safe and enjoy the break!
by Mick
Thu Dec 19, 2013 1:43 pm
Forum: Technical
Topic: No power after turning off engine
Replies: 12
Views: 557

Hey mate, if you have replaced the fusible link itself with copper conductor you will leave that part of the car with no circuit protection so if there is an overload or fault, it will heat up until it burns and breaks the circuit, which will be after the car is turned to ash. An easy fix is to get ...
by Mick
Wed Dec 18, 2013 8:52 am
Forum: Show And Go
Topic: JA83's car
Replies: 58
Views: 7717

looks unreal mate, if you need a hand with anything just sing out!
by Mick
Thu Dec 12, 2013 3:07 pm
Forum: Twin Cam Land
Topic: Is a Tremec T-56 strong enough?
Replies: 15
Views: 1385

Hey Aaron,

I see in the other thread that you bought the t-56, and just wanted to say that it is an excellent decision.
by Mick
Fri Dec 14, 2012 3:18 pm
Forum: General Discussion
Topic: Tasmania
Replies: 7
Views: 1328

That makes sense mate i was a bit stumped thinking of blokes that had moved to bathurst! i guess it is a fairly high percentage of twin cams to single, maybe its that commuting here is so easy because its small so modifying is a bit more practical. its been so long ive forgotten! Hows Headland treat...